Intermediatespecial sensesPhysiology

Phototransduction: How Light Becomes a Neural Signal

Overview

Vision begins when photons strike photoreceptors in the retina and trigger phototransduction, a biochemical cascade that converts light into an electrical signal. Unusually, light hyperpolarizes photoreceptors rather than depolarizing them: photons close sodium channels, reducing the steady release of glutamate. This inverted logic, decoded by bipolar and ganglion cells, is the foundation of all sight.

Learning objectives

  • Sequence the phototransduction cascade from photon to hyperpolarization.
  • Explain why photoreceptors hyperpolarize in response to light.
  • Compare rods and cones in sensitivity, acuity, and color vision.
  • Describe dark adaptation and the role of rhodopsin regeneration.

Process steps

1
Photon strikes the photopigment

A photon isomerizes 11-cis retinal to all-trans retinal within rhodopsin (rods) or a cone opsin, activating the receptor molecule.

2
Transducin G protein activates

Activated opsin stimulates many transducin molecules, beginning the amplification cascade.

3
PDE hydrolyzes cGMP

Transducin activates phosphodiesterase, which rapidly converts cGMP to GMP, dropping cytoplasmic cGMP levels.

4
Na+ channels close; cell hyperpolarizes

Without cGMP, gated Na+ channels in the outer segment close, the dark current stops, and the membrane hyperpolarizes toward -70 mV.

5
Glutamate release falls

Hyperpolarization reduces Ca2+-dependent glutamate release at the synaptic terminal, signaling light to bipolar cells.

6
ON/OFF channels decode the change

ON bipolar cells depolarize (sign-inverting metabotropic receptors) and OFF bipolars hyperpolarize, splitting the signal for contrast processing.

Key variables

VariableUnitTypical rangeRole
Dark membrane potentialmV~-40Depolarized state maintained by the cGMP-gated dark current in darkness.
Light membrane potentialmV~-70Hyperpolarized state after Na+ channel closure in bright light.
Dark adaptation timemin~20-30Time for full rod rhodopsin regeneration and maximum night sensitivity.

Rods and cones: two photoreceptor systems

The retina contains about 120 million rods and 6 million cones. Rods are exquisitely sensitive, detecting single photons, and handle dim-light (scotopic) vision, but they provide no color and poor acuity. Cones need bright light and concentrate in the fovea, where they deliver sharp, color (photopic) vision through three types (S, M, L) tuned to short, medium, and long wavelengths. The fovea contains only cones, which is why you must look directly at something to see it sharply.

The dark current: depolarized in darkness

In darkness, photoreceptors are relatively depolarized (about -40 mV) because cGMP holds sodium channels open in the outer segment, letting Na+ flow in: this steady inward current is the dark current. The depolarized terminal continuously releases glutamate onto bipolar cells. Photoreceptors are therefore unusual neurons that are active in the dark and silenced by their adequate stimulus, an arrangement that makes the system extremely sensitive to small decreases in transmitter release.

The phototransduction cascade

When a photon strikes rhodopsin (rods) or a cone opsin, it isomerizes the retinal chromophore from 11-cis to all-trans, activating the opsin. Activated opsin stimulates the G protein transducin, which activates phosphodiesterase (PDE). PDE hydrolyzes cGMP to GMP, cGMP levels fall, the cGMP-gated Na+ channels close, and the cell hyperpolarizes toward about -70 mV. The cascade amplifies enormously: one photon can close hundreds of channels by activating many transducin and PDE molecules.

Light hyperpolarizes

Unlike most receptors, photoreceptors hyperpolarize to their stimulus. Light closes Na+ channels, the dark current stops, and glutamate release falls. Darkness is the active state.

From hyperpolarization to the optic nerve

Reduced glutamate release is read differently by two bipolar cell types. OFF bipolar cells have ionotropic glutamate receptors, so less glutamate hyperpolarizes them (they signal darkness decreases). ON bipolar cells have metabotropic receptors that invert the sign, so less glutamate depolarizes them (they signal light increases). Bipolar cells feed retinal ganglion cells, whose axons form the optic nerve. Lateral processing by horizontal and amacrine cells adds contrast enhancement before the signal ever leaves the eye.

Color vision and the three cone types

Color perception comes from comparing the outputs of S (blue), M (green), and L (red) cones, each with an opsin tuned to a different wavelength peak. The brain computes color from the ratios of their activation, which is why different spectral mixtures can look identical (metamers). Most color blindness is red-green, caused by missing or shifted M or L opsins on the X chromosome, affecting about 8 percent of males.

Dark adaptation and rhodopsin regeneration

Bleached rhodopsin must be regenerated before full sensitivity returns: all-trans retinal is recycled through the retinal pigment epithelium back to 11-cis, a process taking 20-30 minutes for complete dark adaptation. Cones adapt within minutes, rods take much longer, which is why entering a dark theater blinds you briefly. Vitamin A is the precursor of retinal, so deficiency causes night blindness before any other symptom.

Key points

  • Photoreceptors are depolarized in darkness (dark current) and hyperpolarize in light.
  • Photon → rhodopsin → transducin → PDE → cGMP falls → Na+ channels close.
  • One photon closes hundreds of channels: massive biochemical amplification.
  • ON and OFF bipolar cells split the signal into light-increase and light-decrease channels.
  • Rods serve dim light; three cone types (S, M, L) serve bright light and color.

Common misconceptions

✗ Myth: Light depolarizes photoreceptors like other receptors.

✓ Truth: Phototransduction is inverted: light closes cGMP-gated Na+ channels and hyperpolarizes the cell. The dark current means darkness, not light, is the depolarized state.

✗ Myth: Rods and cones both see color, just at different brightness.

✓ Truth: Only cones contribute to color vision, via three opsin types. Rods are monochromatic; that is why the world looks colorless in very dim light.

Practice questions

Q1. In darkness, a rod photoreceptor is:
  1. Hyperpolarized with Na+ channels closed
  2. Depolarized with Na+ channels open
  3. At -70 mV resting
  4. Releasing no glutamate
Answer: B.

In darkness cGMP holds Na+ channels open (the dark current), keeping the rod depolarized near -40 mV and steadily releasing glutamate. Light closes these channels.

Q2. The phototransduction cascade causes cGMP levels to:
  1. Rise, opening Na+ channels
  2. Fall, closing Na+ channels
  3. Stay constant
  4. Convert to cAMP
Answer: B.

Activated PDE hydrolyzes cGMP, cGMP falls, cGMP-gated Na+ channels close, and the photoreceptor hyperpolarizes.

Q3. Color vision depends on:
  1. Rods with rhodopsin
  2. Three cone types with different opsins
  3. Ganglion cell melanopsin only
  4. Bipolar cell diversity
Answer: B.

S, M, and L cones each carry an opsin tuned to short, medium, or long wavelengths; the brain computes color from their activation ratios.

Click a question to reveal the answer and explanation.

Frequently asked questions

Why does it take so long to see in the dark?

Bleached rhodopsin regenerates slowly through the retinal pigment epithelium. Cones recover in minutes, but full rod sensitivity, which dominates night vision, takes 20-30 minutes.

Why can't you see color in dim light?

Cones need bright light to function. In dim conditions only rods respond, and with a single photopigment type they cannot encode wavelength, so night vision is monochromatic.

What does vitamin A have to do with vision?

Vitamin A (retinol) is the precursor of 11-cis retinal, the light-catching chromophore of rhodopsin. Deficiency impairs rhodopsin regeneration and causes night blindness.