FoundationsnervousPhysiology

The Action Potential Mechanism

Overview

The action potential is the fundamental electrical signal of the nervous system — a brief, all-or-none reversal of membrane voltage that carries information along axons. It arises from the coordinated opening and closing of voltage-gated ion channels and follows a strict sequence: resting state, threshold-triggered depolarization, Na+ inactivation, K+-driven repolarization, and a short refractory period before recovery.

Learning objectives

  • Describe the membrane state before an action potential begins.
  • Explain how threshold triggers an all-or-none spike.
  • Sequence the roles of voltage-gated Na+ and K+ channels during the rising and falling phases.
  • Distinguish the absolute and relative refractory periods.
  • Relate ionic gradients and the Na+/K+ pump to recovery after firing.

Process steps

1
Resting state before firing

The axonal membrane sits at a resting membrane potential of about -70 mV, maintained by the Na+/K+ ATPase and high resting K+ permeability. Voltage-gated Na+ and K+ channels are closed, with their activation gates shut and Na+ channel inactivation gates open.

2
Stimulus depolarizes the membrane

A graded stimulus opens ligand- or mechanically-gated channels, letting positive ions (usually Na+) enter. If the resulting depolarization reaches the threshold of about -55 mV at the axon hillock, an action potential is triggered; below threshold, the signal simply fades away.

3
Rising phase: Na+ rushes in

At threshold, voltage-gated Na+ channels snap open. Na+ flows down its electrochemical gradient into the axon, driving a positive feedback loop: more depolarization opens more Na+ channels. The membrane potential shoots upward toward about +30 mV, the peak of the spike.

4
Falling phase: Na+ inactivation and K+ efflux

At the peak, Na+ channels inactivate (their inactivation gates close even though activation gates remain open). Slightly delayed voltage-gated K+ channels open, allowing K+ to flow out. This combined change reverses the membrane potential back downward.

5
Hyperpolarization undershoot

K+ efflux continues briefly past the resting level because voltage-gated K+ channels close slowly, driving the membrane to about -80 mV. During this relative refractory period, a much stronger-than-normal stimulus is needed to fire again.

6
Resting potential is restored

Voltage-gated K+ channels close and the membrane returns to about -70 mV. The Na+/K+ ATPase (3 Na+ out, 2 K+ in per ATP) gradually restores the ionic concentration gradients, and Na+ channel inactivation gates reset so the axon is ready to fire again.

Key variables

VariableUnitTypical rangeRole
Resting membrane potentialmV-60 to -90 (-70 typical)Baseline voltage set by K+ leak and the Na+/K+ pump; the reference point every phase of the spike is measured against.
Threshold potentialmV~-55Critical voltage at which voltage-gated Na+ channel activation outruns K+ leak, committing the axon to an all-or-none spike.
Peak potentialmV~+30Maximum depolarization; limited by the Na+ equilibrium potential (~+60 mV) and the timing of Na+ channel inactivation.
Hyperpolarization nadirmV~-80Brief undershoot after the spike caused by lingering K+ efflux; sets the relative refractory period.
Absolute refractory periodms~1-2Window during which no stimulus, however strong, can trigger another spike because Na+ channels are inactivated.

Feedback loops

Na+ positive feedback during rising phase positive feedback

  1. Depolarization opens voltage-gated Na+ channels
  2. Na+ influx further depolarizes the membrane
  3. More depolarization opens more Na+ channels
  4. Cycle continues until Na+ channels inactivate

Na+ channel inactivation loop negative feedback

  1. Strong depolarization triggers Na+ channel inactivation
  2. Na+ influx stops as channels close
  3. Membrane repolarizes via K+ efflux
  4. Inactivation gates reset as resting potential returns

What an action potential is

An action potential is a rapid, transient change in membrane voltage that propagates along an axon without losing amplitude. It is all-or-none: once threshold is crossed, the full stereotyped waveform plays out. The spike lasts only about 1–2 milliseconds in a typical neuron, yet it is the currency of neural communication.

All-or-none law

Stimulus strength beyond threshold does not make a bigger spike — it changes firing frequency instead. Information is coded in spike rate and timing, not amplitude.

Ion gradients set the stage

Concentration gradients make the spike possible: K+ is high inside the cell, while Na+ and Cl- are high outside. The Na+/K+ ATPase builds these gradients by pumping 3 Na+ out and 2 K+ in per ATP. At rest, K+ leak channels dominate, so the membrane sits near the K+ equilibrium potential of about -70 mV.

The axon hillock as decision point

Graded potentials from dendrites and the soma summate at the axon hillock, which has the highest density of voltage-gated Na+ channels. When depolarization reaches about -55 mV, the balance tips: Na+ influx exceeds K+ efflux and the positive feedback loop of channel opening drives the membrane toward +30 mV.

Why the spike ends

Two mechanisms terminate the rising phase. Voltage-gated Na+ channels inactivate — their inactivation gates swing shut shortly after opening and cannot reopen until the membrane repolarizes. Meanwhile, slower voltage-gated K+ channels open, and K+ efflux drives the membrane back down.

Inactivation vs closing

An inactivated Na+ channel is distinct from a closed one: its activation gate is open but its inactivation gate is shut. Reset requires repolarization, which is why absolute refractoriness exists.

Refractory periods enforce one-way signaling

During the absolute refractory period (~1–2 ms), inactivated Na+ channels cannot reopen, so no new spike is possible — this caps firing frequency at roughly 500–1000 Hz. In the relative refractory period, lingering K+ efflux means only an unusually strong stimulus can reach threshold again.

From spike to signal propagation

The local depolarization of one membrane patch depolarizes the adjacent patch, triggering its own spike. In unmyelinated axons this happens continuously; in myelinated axons the signal jumps between nodes of Ranvier. Either way, each segment regenerates the full action potential waveform.

Key points

  • Resting potential is about -70 mV; threshold is about -55 mV; the peak reaches about +30 mV.
  • The rising phase is driven by voltage-gated Na+ influx in a positive feedback loop.
  • The falling phase results from Na+ channel inactivation plus delayed K+ efflux.
  • The action potential is all-or-none; stimulus strength is encoded as firing frequency.
  • Absolute and relative refractory periods limit firing rate and enforce forward propagation.

Common misconceptions

✗ Myth: The action potential gets weaker as it travels down the axon.

✓ Truth: In a healthy axon each segment regenerates the full spike, so amplitude stays constant from hillock to terminal. The graded pre-spike signal decays, but the action potential itself does not.

✗ Myth: Positive ions are used up each time a neuron fires.

✓ Truth: The ion movements of a single spike barely change concentration gradients; the Na+/K+ ATPase continuously restores them, so neurons can fire thousands of times per second without depletion.

✗ Myth: K+ channels open at exactly the same time as Na+ channels.

✓ Truth: Voltage-gated K+ channels respond more slowly. This delay is what allows the full rising phase before repolarization begins.

Practice questions

Q1. Which event directly produces the rising phase of the action potential?
  1. K+ efflux through voltage-gated channels
  2. Na+ influx through voltage-gated channels
  3. Closing of Na+ inactivation gates
  4. Activation of the Na+/K+ ATPase
Answer: B.

The rising phase is driven by rapid Na+ entry through voltage-gated Na+ channels once threshold is crossed; K+ efflux comes later and causes repolarization.

Q2. The absolute refractory period exists because:
  1. K+ channels are slow to close
  2. voltage-gated Na+ channels are inactivated and cannot reopen
  3. the Na+/K+ pump runs out of ATP
  4. the threshold rises permanently after each spike
Answer: B.

During the absolute refractory period, Na+ channels are in their inactivated state and cannot be reopened by any stimulus until the membrane repolarizes.

Q3. A neuron at -50 mV (above threshold) will:
  1. fire a larger-than-normal action potential
  2. fire a normal, all-or-none action potential
  3. stay depolarized without firing
  4. fire only if K+ channels open first
Answer: B.

Above threshold the all-or-none law applies: the spike has its standard amplitude regardless of how far above threshold the membrane is depolarized.

Q4. The undershoot after an action potential is caused mainly by:
  1. slow closure of voltage-gated K+ channels
  2. rapid opening of Na+ channels
  3. the Na+/K+ pump moving 3 Na+ out
  4. closure of ligand-gated channels
Answer: A.

Voltage-gated K+ channels close slowly, so K+ continues to leave after repolarization, briefly driving the membrane to about -80 mV.

Click a question to reveal the answer and explanation.

Frequently asked questions

Why is -55 mV called the threshold?

It is the voltage at which voltage-gated Na+ influx just exceeds the counteracting K+ leak and efflux. Beyond that point the positive feedback loop of Na+ channel opening takes over, making the spike self-regenerating and all-or-none.

What causes the dip below resting potential after a spike?

Slow closure of voltage-gated K+ channels lets K+ keep leaving the cell briefly after the membrane has returned toward rest, driving the potential to about -80 mV before it settles back to -70 mV.

Can a neuron fire during the absolute refractory period?

No. Inactivated voltage-gated Na+ channels cannot reopen until the membrane repolarizes and their inactivation gates reset, so no stimulus — however strong — can trigger a second spike in this ~1–2 ms window.

What does the Na+/K+ pump do between spikes?

It exports 3 Na+ for every 2 K+ it imports, using one ATP. This maintains the concentration gradients and contributes a small net outward current, restoring the axon for the next action potential.